Start with measurement points
A useful chart lists the points that matter for the garment, not every dimension on a pattern. For a jersey: chest, body length, shoulder width, sleeve length and hem width. For bib shorts: waist, hip, thigh, inseam and outseam.
Skinsuits need the torso length and the zip length as well, since the suit has to sit correctly from shoulder to pad without pulling. Accessories use their own charts — cap circumference, sleeve bicep, sock height and glove palm.
Each point needs a target measurement per size and an acceptable tolerance. Without a tolerance, a 1 cm difference becomes a dispute instead of a normal production range. Send your existing chart if you have one, or your reference garment measured flat.
Fit is a decision, not a default
The same chest measurement can produce a race fit, an endurance fit or a relaxed club fit depending on the block and the ease built into it. Decide which one the program needs before the sample is cut.
- Race fit: close to the body, short front, long zip — criterium and road race jerseys.
- Endurance fit: slightly more room through the chest for long days and mixed groups.
- Club fit: a straighter block with more ease, often chosen for a wide membership.
- Gravel and touring: room through the shoulders and pockets for hours off-road.
State the fit in words as well as measurements. Two charts with the same numbers can still feel different if the shoulder, armhole or hem is shaped differently.
Bibs, pad and leg length
Bib shorts are where fit and function meet. The pad has to stay in contact with the saddle through the pedal stroke, so the short cannot be too loose at the leg or too short in the torso.
Pad density is a separate decision from size. A race pad and an endurance pad sit differently in the same short, and the leg length changes how the gripper sits above the knee.
Approve the pad, the leg length and the gripper on the sample together. Changing one after approval is a new sample, not a sizing correction.
Splitting a club order
Build the split from the riders you actually have. List each rider, their size and whether the piece is a rider or staff item, then total by size and colourway.
Most orders need more medium and large than small and extra large, but the ratio changes with the group, the fit and the gender mix. A women's cut is a different block, not a scaled men's size, and needs its own chart.
Confirm the split before production. The cut plan, the packing list and the label count all follow from it, and changes after cutting are expensive to absorb.
Approving fit before bulk
The sample is where fit is approved. Have it tried on the riders who will wear it, across the edges of the size curve — usually a small and an extra large — rather than only the middle size.
Check movement as well as static fit: holding the drops, getting out of the saddle, reaching the rear pockets and, for triathlon, the aero position. A jersey that measures correctly but restricts the armhole is not approved.
Record the approved measurements, the fit description and any changes in one comment round. That record is what bulk is checked against at the inspection stages.